Gold Coast – fixed price – 24/7
Power Point Installation Gold Coast
Extra power points, faulty outlet repairs and switch upgrades, done by licensed electricians at a fixed price.
- QLD licence 1511406
- Fixed price before work starts
- Lifetime workmanship warranty
- 24/7 emergency call-outs
Power point hot, scorched or crackling?Stop using it and switch that circuit off at the switchboard if it's safe. Smoke, fire or a shock: call 000.
Call 0421 333 034What Clients Say About Knight Electrical Solutions
Do You Need More Power Points?
If you rely on extension leads or piggy-backed double adaptors, probably. The Electrical Safety Office says never to overload power points with multiple double adaptors, and suggests more power points if you need more outlets.
We check the circuit can carry the extra load first.
Then you get a fixed price before any work starts.
Call Us Today
- Hot or warm to touch
- Scorch marks or melted plastic
- Burning smell
- Buzzing or crackling
- Sparks when you plug in
Good Reasons to Upgrade
- Leads across the floor
- Double adaptors stacked up
- Loose or cracked outlets
- Switch stopped working
- No outdoor power
- Dated switchplates
Read a burning smell from a power point or how much one power point can take.
Power Point and Switch Work We Do
Many jobs are a swap or an extra outlet. Some need a new circuit for a high-draw appliance.
Extra Power Points
New outlets where you use them, on a circuit that can take the load.
Adding power points to a roomFaulty and Burnt Outlets
Hot, scorched or loose power points replaced, and the wiring behind them checked.
USB Power Points
Standard sockets with USB charging built in, often swapped into existing outlets.
Switches and Dimmers
Broken, dated or mismatched switches replaced. LED-compatible dimmers fitted.
Replacing light switchesOutdoor Power Points
Weatherproof, IP-rated outlets for decks, garages and gardens, with safety switch protection.
15A and Appliance Outlets
15A outlets and dedicated circuits for heaters, spas and high-draw appliances.
Spa and pool powerWhy Gold Coast Homeowners and Businesses Choose Knight Electrical Solutions
Price Quoted on Site
We inspect first. The quote is the number you pay.
Workmanship Warranty
If our work fails, we come back and fix it.
Emergency Call-Outs
Based in Palm Beach, so same-day is often possible.
Licensed and Insured
QLD Electrical Contractor Licence, fully insured.
Years' Experience
Residential, commercial and industrial work.
Pay on Completion
Paid on site when the job's done. No invoice to chase.
What Queensland Says About Power Points
From the Electrical Safety Office and the Electrical Safety Regulation 2026.
New or Moved Power Points Need an Electrician
Installing a new power point, moving one, or replacing a light switch is electrical work. It must be done by a licensed electrician.
What you can legally DIYSource: Electrical Safety Office
Replace Damaged Outlets Straight Away
The Electrical Safety Office says to replace damaged power points, wall switches and frayed leads immediately. Power points and switches must be replaced by a licensed electrician.
Source: 9 ways to make your home safe, Electrical Safety Office
Don't Piggy-Back Double Adaptors
Never overload a power point with multiple double adaptors. If you need more outlets, you can have more power points installed or use a power board.
How much can one point take?Source: 9 ways to make your home safe, Electrical Safety Office
Keep Power Boards Out of Wet Areas
Don't use power boards or double adaptors in wet areas like laundries and bathrooms. Consider replacing old boards that have no overload cut-out.
Source: Electrical safety in the home, Electrical Safety Office
Safety Switches on Power Point Circuits
A new owner has 90 days from taking possession to have a safety switch fitted for the general power points. A landlord has 90 days from the start of a new tenancy.
Source: Electrical Safety Regulation 2026, ss 28 and 29
Having Electrical Work Done?
With limited exceptions, such as urgent emergency or safety work, an electrician can't do installation work in a home without a safety switch on the power points unless the job includes fitting one.
Source: Electrical Safety Regulation 2026, s 30
A plain-English summary, not legal advice. Selling? Read do you need a safety switch to sell a house in QLD.
Byron Knight
Director, Knight Electrical Solutions
Byron has more than 20 years of hands-on experience across residential, commercial and industrial electrical work, from family homes and rural properties to large-scale projects. That depth shows in how quickly and accurately he gets to the cause of a fault.
He has run his own electrical business before, so he knows what it takes to lead a job from the first call to a clean handover. He's also trained in PLC and instrumentation and qualified in Level 1 thermal imaging, so complex jobs are well within his wheelhouse.
What drives him is quality: neat, safe work, straight advice and a finished job he's proud to put the Knight name to. Do it once, do it right.
- QLD Electrical Contractor Licence 1511406
- 20+ years' experience
- PLC and instrumentation
- Level 1 thermal imaging
How It Works
- Get in Touch
Tell us where you need power or what's faulty.
- On-Site Check
We check the circuit, the load and cable routes.
- Fixed Price
One figure before work starts. No hourly rate.
- Outlets Installed
Cables run, outlets and switches fitted neatly.
- Tested
New outlets and switches tested before we leave.
- Pay on Completion
EFTPOS on site when you're happy.
For larger jobs over $5,000 in materials that span multiple days, a deposit may be requested when the quote is accepted.
What Sets the Price of Power Point Work
A straight swap costs least. A new outlet on a new circuit costs most. These are the things that move the number.
- Swap or new. Replacing an outlet is quicker than adding one.
- Number of outlets. Several in one visit share the setup time.
- Cable route. Wall type and roof or underfloor access.
- Circuit capacity. A full circuit may need a new one run.
- Outlet type. USB, weatherproof or 15A outlets.
- Faults found. Burnt or damaged wiring may need repair first.
Commercial and strata
Power and Switches for Businesses and Body Corporates
Shops, offices and strata buildings often need extra outlets after a layout change. We add circuits and outlets, can work around your trading hours, and quote a fixed price up front.
Power Point FAQ
Questions Gold Coast homeowners ask us about power points, outlets and switches.
Can I install or replace a power point myself in Queensland?
No. The Electrical Safety Office lists installing a new power point, moving an existing one and replacing a light switch as electrical work. That must be done by a licensed electrician. Unlicensed electrical work is illegal, and if it causes a fire your insurer may refuse the claim. Buying hard-wired accessories isn't illegal, but a licensed electrician must connect them and test the work.
How much does it cost to install a power point?
It depends on the job, so we price it on site. Swapping an existing outlet costs least. A new outlet costs more, especially if the cable route is hard or the circuit is already full and needs a new one. The outlet type, the number of outlets and any damaged wiring we find also matter. You get one fixed price before work starts.
Why is my power point warm or making a noise?
Usually a loose or deteriorating connection, or a circuit carrying too much load. Both make heat, and heat at a power point can be a fire risk. Unplug what you can safely, stop using it and switch off that circuit at the switchboard if it's safe. If there's smoke or fire, call 000. Otherwise call a licensed electrician to find the cause.
Should I replace old or discoloured power points?
Yes. Discolouration, cracks, scorch marks or a loose fit are warning signs. Brown or melted plastic usually means a connection has been running hot. The Electrical Safety Office says to replace damaged power points and wall switches immediately, and that has to be done by a licensed electrician. Stop using the outlet until then. We replace it and check the wiring behind it.
Is it safe to use double adaptors and power boards?
Only within limits. The Electrical Safety Office says never to overload a power point by plugging in multiple double adaptors. Keep power boards out of wet areas such as laundries and bathrooms, and consider replacing old boards with no overload cut-out. If you're relying on leads and adaptors every day, a more permanent fix is more power points. We check the circuit can carry them.
Can you install USB power points?
Yes. A USB power point is a standard socket with USB charging ports built in, so you can charge phones and tablets without a plug pack. They can often go where an existing outlet is, so it's frequently a straight swap. We check the outlet box and the wiring behind it, then fit and test the new outlet. They suit kitchens, bedrooms and home offices.
Can you install weatherproof outdoor power points?
Yes. Outdoor power points need to be weatherproof and IP-rated, mounted where water won't pool, and on a circuit with safety switch protection. Gold Coast salt air can corrode indoor-rated outlets quickly. We fit outdoor outlets for decks, garages, sheds and gardens, and can add a dedicated circuit for pool or spa equipment where it's needed.
Can you replace all the switches and power points in my house?
Yes. Many people do this after painting or when switchplates have yellowed or cracked. We can replace the switches and outlets through the house, often in one visit, quoted at a fixed price. While they're off the wall, we look at the connections and tell you about anything that needs attention. If there's no safety switch on the power points, we tell you before quoting whether one is needed.
Our Service Area
Our electricians cover the whole Gold Coast and Tweed Heads.
- Gold Coast
- Ashmore
- Austinville
- Benowa
- Biggera Waters
- Bilinga
- Bonogin
- Broadbeach
- Bundall
- Burleigh Heads
- Burleigh Waters
- Carrara
- Coolangatta
- Coombabah
- Currumbin
- Currumbin Waters
- Elanora
- Helensvale
- Highland Park
- Hollywell
- Hope Island
- Kirra
- Labrador
- Main Beach
- Mermaid Beach
- Mermaid Waters
- Merrimac
- Miami
- Molendinar
- Mudgeeraba
- Nerang
- Nobby Beach
- Palm Beach
- Paradise Point
- Reedy Creek
- Robina
- Runaway Bay
- Southport
- Surfers Paradise
- Tallai
- Tallebudgera
- Tugun
- Tweed Heads
- Varsity Lakes
- Worongary
Get Your Power Points Quoted
We'll check the circuit and give you a fixed price before any work starts.
0421 333 034
If anyone is in danger, has had an electric shock, or you can see fire, sparks or fallen powerlines, call Triple Zero (000) immediately. Don’t touch anyone who may be in contact with live electricity.
Important disclaimer
The information on this page is general and is not advice for your property. Summaries of Queensland law and standards are drawn from the official sources linked on this page, and may change; the official sources prevail. Regulations, Australian Standards and safety requirements change, and errors can occur, so have a licensed electrician assess your situation in person before acting on anything here. Electrical work in Queensland must only be done by a licensed electrician. If you think something here is wrong or out of date, call 0421 333 034 or email byron@knightes.au and we'll review it. To the extent permitted by law, Knight Electrical Solutions accepts no liability for loss or damage arising from reliance on this information.